Deionized Water System LDIN-A10 is smallest and most compact lab water system from tap to ultrapure water, integrating pretreatment, RO, DI, UV, UF and terminal filter into one. Its output ranges from 15 to 30 liters/hour and offers flow rate up to 2 liters/minute (with pressure tank). Features with tap water inlet, it can produce single stage RO water and deionized water. The single stage RO water’s ion rejection rate is more than 96%, and the deionized water’s resistivity is more than 15 MΩ.cm, near to 18.2 MΩ.cm. It completely meets the requirements of general chemical or biological experiments for pure water. Designed with apheliotropic LCD display, to detect the quality of deionized or ultrapure water. Equipped with Ultrafiltration module, effectively eliminate endotoxin and suitable for precise cell cultivating and IVF. Double wavelength (185 & 254 nm) ultraviolet lamp module, restrain bacteria increase and reduce TOC. It is auto self-flushing of RO membrane function, extend RO membrane life.
| Output | 30 liters/hour |
| Flow rate | Up to 2 liters/minute (with pressure tank) |
| Pure water outlet | 2 reverse osmosis water, deionized water |
| Deionized Water Quality | Resistivity: 16 to 18.2 M Ω cm<br/> Bacteria: N/A<br/> Particle (>0.1 µm): N/A |
| RO Water Quality | Ion rejection rate: 97 % to 99% (new RO membrane)<br/> Organic rejection rate: >99 %, when MW >200 Dalton<br/> Particles and bacteria rejection rate: >99 % |
| Feed water requirements | Tap water, Temperature 5 to 45°C, Pressure 1.0 to 4.0 Kgf/cm<sup>2</sup> |
| Dimension | 410 × 220 × 420 mm |
| Power Consumption | 72 W |
| Power Supply | AC100 to 240 V, 50/60 Hz |
| Weight | about 18 kg |
| Standard configuration | Main body (Including 1 set of cartridge) +15 liters pressure tank+ TDS/conductivity test pen |
- Designed with microcomputer controlling system and electronic pressure sensor
- Auto self-flushing of RO membrane function, extend RO membrane life
- Equipped with top cap of pretreatment in the case can be rapidly opened to replace the cartridges without opening the case
- Offers 4 independent ultrapure cartridges
- Ultrapure water quality up to 18.2 MΩ.cm, with the lowest TOC level and running cost
- Whole unit with one time injection molding process
- Material used polypropylene, avoid rusting and keep clean, to meet GLP standard
- Designed with apheliotropic LCD display, to detect the quality of deionized or ultrapure water
- Offers attached portable TDS (total dissolved solid) conductivity test pen, with dry cell design, to detect the quality of feed water and RO water
- Double wavelength (185 & 254 nm) ultraviolet lamp module, restrain bacteria´s increase and reduce TOC
- Ultrafiltration module, effectively eliminate endotoxin and suitable for precise cell cultivating and IVF
- Double layer PES terminal disinfection filter, assure that terminal pure water is absolutely axenic
Deionized Water System
Deionized Water System LDIN-A20
- Output
- 30 liters/hour
- Flow rate
- Up to 2 liters/minute (with pressure tank)
- Pure water outlet
- 2 reverse osmosis water, deionized water
Type I and Type III Water Purification System
This water purification system is a combinational system that produces Type III water after RO and Type I water after deionization in one cycle
Type I and Type III RO Water Purification System LOTW-B12
- Output of Pure water
- ≥ 30 L / hr.
- Water Type
- Type I and Type III
- Water Tank capacity
- 30 L
Type I and Type III RO Water Purification System LOTW-A13
- Output of Pure water
- ≥ 40 L / hr.
- Water Type
- Type I and Type III
- Water Tank capacity
- 80 L
Type I and Type III RO Water Purification System LOTW-A11
- Output of Pure water
- ≥ 20 L / hr.
- Water Type
- Type I and Type III
- Water Tank capacity
- 30 L
Type I and Type III RO Water Purification System LOTW-B20
- Water production rate
- ≥ 30 L/h
- Water intake rate
- 1.5 to 1.8 L/min
- Temperature
- 5 to 40°C
Type II Water Purification System
This water purification system provides Type II level water with consistency and reliability. It removes approximately 98% of inorganic ions and 99 % of all dissolved organic substances
Type II Water Purification System LTWP-A13
- Output of Pure water
- ≥ 40 L / hr.
- Process
- Single Pass RO system
- Water Type
- Type II
Type II Water Purification System LTWP-A14
- Output of Pure water
- ≥ 50 L / hr.
- Process
- Single Pass RO system
- Water Type
- Type II
Type II Water Purification System LTWP-B12
- Output of Pure water
- ≥ 30 L / hr.
- Process
- Double Pass RO system
- Water Type
- Type II
Type II Water Purification System LTWP-B11
- Output of Pure water
- ≥ 20 L / hr.
- Process
- Double Pass RO system
- Water Type
- Type II
Type III Water Purification System
It provides Type III level water which is required for chemical and physical inspection or for washing lab glassware’s
Type III Water Purification System LHWP-B10
- Output of Pure water
- ≥ 10 L / hr.
- Water Type
- Type III
- Configuration
- Benchtop
Type III Water Purification System LHWP-B12
- Output of Pure water
- ≥ 30 L / hr.
- Water Type
- Type III
- Configuration
- Benchtop
Type III Water Purification System LHWP-B13
- Output of Pure water
- ≥ 40 L / hr.
- Water Type
- Type III
- Configuration
- Floor Standing
Type III Water Purification System LHWP-B14
- Output of Pure water
- ≥ 50 L / hr.
- Water Type
- Type III
- Configuration
- Floor Standing
Radio Frequency Identification Water Purification System
Radio Frequency Identification Water Purifier are equipped with a RFID Radio Frequency Identification Chip which helps keeping a check on the quality of water in real time. This helps in monitoring of parameters for the purifier
Radio Frequency Identification Water Purification System LRFW-A10
- Output of Pure water
- ≥ 10 L / hr.
- Process
- Single Pass RO system
- Configuration
- Benchtop
Radio Frequency Identification Water Purification System LRFW-A14
- Output of Pure water
- ≥ 50 L / hr.
- Process
- Single Pass RO system
- Configuration
- Floor Standing
Radio Frequency Identification Water Purification System LRFW-C10
- Feed Water
- Tap Water , TDS ≤ 400 ppm, Water Temperature: 5 to 40°C
- Water Production Rate
- ≥ 10 L/ h, Ultrapure Water Flow Rate 2 L/ min
- Water Quality (Two Stage)
- Ultrapure water: Resistivity: 18.25 MΩ.cm at 25°C conforms to ASTM CAP NCCLS
Radio Frequency Identification Water Purification System LRFW-B11
- Output of Pure water
- ≥ 20 L / hr.
- Process
- Double Pass RO system
- Configuration
- Benchtop
Popular Categories
Navigation
Contact Us Map